Ravo 54G Manuel d'utilisateur télécharger pdf (Page 20)

54Mbps Wireless Access Point User Manual

3.2 Additional Settings for Wireless Client

If you choose to access the router via a wireless client, also verify

the following:

1. Make sure your PC is equipped with 802.11g or 802.11b

wireless adapter and has appropriate WLAN card driver/utility

and TCP/IP installed.

2. Set the wireless adapter to use appropriate TCP/IP settings as

described in previous section.

3. Launch the wireless adapter’s provided utility and verify that

your wireless client is configured with these settings:

•

Operation Mode: Infrastructure

•

SSID: wirelesss

•

Authentication: Open

•

WEP Mode: Disabled

Note

If you only finished the wireless settings and didn’t configure the

wireless adapter’s TCP/IP settings, even your link status indicates a

successful connection with the AP, this connection applies to the

“physical” network layer only. Your wireless adapter cannot

communicate with the AP. Make sure to set the TCP/IP properties as

described in this previous section.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 38 39

Pas de commentaire

Ravo 54G Manuel d'utilisateur Page 20